The engine
Introduction
During the winter, I couldn't work in the garage because there was no heating. During that time, I tackled the engine. First, I built an engine stand to hang the engine on. Then I started tinkering. I've already bought all the parts for an 1835 cc engine, but for now, the 1200 cc should be enough.I removed as many parts as possible and cleaned the engine.
I removed the heater connections and welded the holes shut. All the sheet metal was cleaned and repainted. The engine is a standard 1200cc engine. Modifications include the air filter and a Stinger exhaust without a muffler.
The gaskets were replaced, new oil was added, etc. After that, the engine block could be reattached to the gearbox. I also started building the rear bumper. The ignition coil was moved to the rear of the air cooler.
Update: 2025-11-25 11:49:35